Trouble Shooting for the 2 Function Remote:

Answer the questions listed below and follow
the instructions to solve your problem.

Question	Answer
1.Does your remote operate sporadically or not at all?	SPORADIC Go to question number 2.	NOT AT ALL Skip to question number 3.
2. Does the remote work only when you are close to the car?	YES Try solution number 1.	NO go to question number 3.
3. Does the transmitter indicator light up green when you push the green button and yellow when you push the yellow button?	YES Go to question number 4.	NO Try solution number 2.
4. Can you hear a clicking sound inside the receiver when you push the transmitter buttons?	YES Try solution number 3.	NO Go to question number 5.
5.If you push the code button on the front of the receiver, does the red LED indicator flash?	YES Try solution number 4.	NO Try solution number 5.

Problem Definitions & Solutions

1. You are having a range problem. Try moving the white antenna to a better location. Make sure it is not wrapped around anything steel. You might also try new batteries in the transmitter if it is more than a year old.

2. Your problem is in the transmitter. If only one button fails to light up, the problem is not the batteries. You will have to call for a replacement. If both buttons fail to light, it is probably the batteries. Call if batteries do not correct the problem.

3.The problem is probably not in the remote. Make sure you have a good ground going to the receiver. Test your actuators by placing a hot and ground directly to the back of the actuators. If they fail to actuate, call for a replacement. If they do actuate, reconnect them in the door and place a hot wire on the green and yellow wires. This will test the wire between the remote and actuators. Check your wiring. Do not hold power on the actuators for more than 7 seconds or they will burn out.

4. Your transmitter probably needs re-coded. Click here for coding instructions. Also check your ground wires on the actuators and the receiver.

5. If the red LED stays on all the time when the unit is powered up, the receiver is shorted and must be replaced. If it fails to light at all, you have a bad ground or the unit is shorted.